My setup:
CA G36k
ProWin Hopup Chamber
Madbull blue bucking
SHS Airseal nozzle.
Private Parts M4 Magwell adapter
And a sector chip
The mags I am using to test this are King arms M4 Midcaps and a Tokyo Marui Hicap.
Here's the fun bit: Both mags feed flawlessly with the addition of a spacer between the hopup chamber and the gearbox. This spacer is only .3mm thick
However, without the spacer, the TM mag misses one shot every 5 or 6 and the KA mags fail to load about 1 of every 3 shots.
Another fun fact, the gun will feed fine without the spacer as long as the magwell isn't completely in place.
I want to modify either the magwell or the chamber in such a way that the nozzle/bucking connection is unaffected. So can anyone give me some ideas here? Even though it is a very small spacer I hate to lose any air from a poor seal between the nozzle and the bucking.
Here is a picture of the spacer if that helps:Hey guys, I need some help with a feeding problem I am having with my CA G36k.
