G & G FN2000

[GuyL61]

Ok, stupid question....

I have a G&G FN2000 and want a suppressor for it. Everything I've read on it says it has the 14mm ccw threads under the flash hider, but the problem is the flash hider is either pinned or has an infinitely small allen head set screw on it, I can't tell which. So my question is twofold: 1 which is it, set screw or pinned? 2 Is there a suppressor that will fit over the stock flash hider?

Any help/guidence/point in the right direction would be appreciated.

[TheNinja]

It's an allen key. careful not to round it off though.

[vulrath]

I believe it's a 1.5mm hex headed grub screw.

[hicks]

Finally found an allen wrench that would fit, however the flash hider must be glued on. I used a crescent wrench on the "flats" of the flash hider but it wouldn't budge and I didn't want to break the flash hider. Anyone know of a suppressor that actually fits on or over the flash hider?

[vulrath]

Yes, but most of them require special flash hiders. Is the flash hider metal? If so, try heating it up with a lighter or a hair dryer to break up some of the glue.

You might be able to make something like an SR25 flash hider work, though.

[SpectrE-416]

I would of gone with the SR25K,because even though i have had experiences with bullpups, they almost always have difficulty attaching suppressors.

[vulrath]