reliable high rof gun (30) what parts?

[S.A.T.@Yoshi]

I am looking to find a high rof gun that is reliable, I need to know what parts I need to put in it, I would like it not to break every weekend, any suggestions.

[Jeremy_]

shs 16:1 gears, shs full metal teeth piston, hs5 mosfet, delayer chip, lower spring (m100 or m110), and a Shs high speed motor. Great set-up

[gungin]

if you do a high speed setup and you don't want your gears to melt you need to shoot in burst's of 3-5 never go full auto for 10-25 shots that's why most high speed setup's last less i have a high speed mp5 22rps had it for 6 months now i only spray 3-5 shots in a burst.

[Mr. Fox]

[xandman]

You can always go with a PolarStar (provided you are using a V2 Gearbox). you can push 30 RPS out of them easy and have sustained fire. you could just dump mag after mag and not have to worry about any part failure or motor issues. Yes it will be a little more than you wanted to put in to it ($400-450) but you will have reliability on your side, not to mention you can always up your FPS and swich out nozzles and be shooting harder for times you dont need a BB hose. You can build a high ROF gun and make it reliable by using a standard gearbox and parts (ex. V2,V3,V6) but you will have to worry about long term use even if you go with top of the line parts. Its just an idea and its not every ones cup of tea but the PolarStar fusion engine is great and can do just about everything you would want it too ranging from 30+ RPS in CQB to a 500+FPS DMR.

[cypher]

[Mr. Fox]

[Smartkid312]

Yea I've seen people get 30 rps plus in shs high torques with 16:1. Now shs 7 tooth piston 120 spring VS 16:1 gears shs high torque shim correct AOE and all other mods with a 30c 3000 mah lipo you should be getting 35 rps.

[Mr. Fox]

[S.A.T.@Yoshi]

I'm probably running shs internals, 7 tooth half rack shs high speed motor helical gears, and a 110, on a 25c battery, that's easily 30

[Mr. Fox]