nowwhat the heck do I do?
TN Airsoft Forums
Airsoft forum dedicated to promoting collaboration among active Airsoft enthusiasts within the TN area.
Need help
Moderators: dogsoldier, Skidude, Sniper
37 posts • Page 3 of 3 • 1, 2, 3
by ramborob17 » Mon Feb 12, 2007 6:59 pm
I just got my new spring formy L96 but I went to install it today and the cylinder looks like it has been machine pressed. nowwhat the heck do I do?
nowwhat the heck do I do?-
ramborob17 - Posts: 622
- Joined: Wed Oct 04, 2006 12:33 pm
- Location: Knoxville, Tn
by Sniper » Tue Feb 13, 2007 12:08 am
I highly recommend a newteflon cylinder for it. The stock one won't hold up very long, as i've found out.
Dentrinity has a nice little tool for opening the cylinder. If you go to den trinity, go to the search and type in Type 96. It sohuld be the 1st part shown, with part number TFU009.
Dentrinity has a nice little tool for opening the cylinder. If you go to den trinity, go to the search and type in Type 96. It sohuld be the 1st part shown, with part number TFU009.
-
Sniper - Posts: 12173
- Joined: Sat Jun 03, 2006 3:37 pm
- Location: Collierville
by ramborob17 » Tue Feb 13, 2007 9:09 am
-
ramborob17 - Posts: 622
- Joined: Wed Oct 04, 2006 12:33 pm
- Location: Knoxville, Tn
by ramborob17 » Tue Feb 13, 2007 2:41 pm
-
ramborob17 - Posts: 622
- Joined: Wed Oct 04, 2006 12:33 pm
- Location: Knoxville, Tn
37 posts • Page 3 of 3 • 1, 2, 3
Who is online
Users browsing this forum: No registered users and 28 guests