TN Airsoft Forums
Airsoft forum dedicated to promoting collaboration among active Airsoft enthusiasts within the TN area.
ICS M4 needs help!
Moderators: dogsoldier, Skidude, Sniper
5 posts • Page 1 of 1
ICS M4 needs help!
by MajorHarrison » Fri Nov 05, 2010 5:24 pm
anyone good with ICS M4 near Johnson City
Echo Company Member
ETSU Army ROTC Cadet
U.S. Army Infantry
ETSU Army ROTC Cadet
U.S. Army Infantry
-
MajorHarrison - Posts: 483
- Joined: Fri Feb 08, 2008 7:39 pm
- Location: Bristol, TN
Re: ICS M4 needs help!
by MajorHarrison » Sat Nov 06, 2010 10:26 am
the selector switch is not working there is no safety and the semi and auto selections can sometimes toggle on their own. I can do like ca marui or clone m4s butthisismyfirstICSsoidkhowtofixitlol!
Echo Company Member
ETSU Army ROTC Cadet
U.S. Army Infantry
ETSU Army ROTC Cadet
U.S. Army Infantry
-
MajorHarrison - Posts: 483
- Joined: Fri Feb 08, 2008 7:39 pm
- Location: Bristol, TN
Re: ICS M4 needs help!
by swimpat16 » Sat Nov 06, 2010 10:08 pm
If you can work on a CA or TM, you can work on an ICS. Break the receiver down, and remove the lower gearbox leaving the upper alone. Then make sure your selector plate and everything is working from there. If you have to take the lower gearbox apart, it's alot easier than a regular one because you don't have to worry about the main spring putting tension on the parts.
-
swimpat16 - Posts: 493
- Joined: Thu Jan 29, 2009 7:50 pm
- Location: Knoxville
Re: ICS M4 needs help!
by MajorHarrison » Sun Nov 07, 2010 10:32 am
ok sweet i wasnt sure cause i saw how thick the sides of the gearbox were in the lower so i thougt it would be different hey i greaty appreciate it man hooah!
Echo Company Member
ETSU Army ROTC Cadet
U.S. Army Infantry
ETSU Army ROTC Cadet
U.S. Army Infantry
-
MajorHarrison - Posts: 483
- Joined: Fri Feb 08, 2008 7:39 pm
- Location: Bristol, TN
5 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests