by W048444 » Tue Jun 25, 2013 10:23 pm
Take some snips and cut the cheek out of your mask where it contacts the stock. sandwich a few layers of spandex together and sew them into the cheek hole. you'll have a cheek-to-stock weld that protects your face when aiming the rifle.
I did it to a paintball mask. I cut an arch beginning at the bottom of the mask on the right corner off my mouth ask the way up to my right earlobe. I cut up a spandex shirt and ran the existing hem from the bottom of the shirt from the chin diagonally up to the ear soit was stretched tight. I used a hot needle to melt holes along the arch so I could stretch the spandex right along it and sew it into place. it worked beautifully.
2011 Viper Tech M4A1 CO2 GBBR